Ram-mount RAM-HOL-MOT3FU Manuel d'utilisateur télécharger pdf

STEP 2

STEP 3

STEP 1

STEP 4

Step 1- Place insert nuts in holes of base from ball side. Install & tighten 2 qty. #6-32 X 3/8” long flat

head machine screws from the back side of ball base and tighten.

Step 2 - Install & tighten 1 qty #8-32 X 3/8” long pan head machine screw into nylock nut through top

center of metal plate and through adjustable latch. (Note: position the adjustable latch to fit either

standard battery or the long life battery of the LS 800) Install and tighten 2 qty #8-32 X 5/8 long pan

head machine screws with nuts into the RAM ball base.

Step 3- Insert 2 qty # 4 X 3/4” long pan head sheet metal screws though 2 qty plastic wire clamps.

Slide 2 qty plastic stand offs over the screws. Then assemble those 2 screws with the 2 remaining

into the four corners of the fan. Note: Routing for fan cable & wire clamps to match photo.

Step 4- Tighten the screws which hold the fan onto tablet cradle, for the best sealing of air flow and

plug in the USB cable. Note: the fan blows into the LS 800.

www.RAM-Mounts.com

INSTALLATION INSTRUCTIONS FOR RAM CRADLE WITH FAN

FOR MOTION COMPUTING LS800 PEN TABLET PC

RAM-HOL-MOT3FU

STEP 2STEP 3STEP 1STEP 4Step 1- Place insert nuts in holes of base from ball side. Install & tighten 2 qty. #6-32 X 3/8” long flat head machine sc

Pas de commentaire

Ram-mount RAM-HOL-MOT3FU Manuel d'utilisateur