Ram-mount Uni-Conn™ Assembly Guide for RAM Tab-Lock™ & T Manuel d'utilisateur télécharger pdf

CHANGING LOCK COMBINATION:

UNLOCK MODE:

RAM UNI-CONN™ ASSEMBLY GUIDE FOR APPLE IPAD

WARNING: BACKUP CODE NOT AVAILABLE IF

COMBINATION IS FORGOTTEN OR LOST.

FACTORY PRESET: “1 1 1 1”

TO UNLOCK, ALIGN PRESET OR CURRENT COMBINATION (A) AND

PULL PLUNGER OUTWARD (B) UNTIL INDENTATION IS VISIBLE

NEXT TO ARROW (C).

2. ON REVERSE SIDE, LOCATE SQUARE NOTCH ON OF SLOT

TO THE LEFT OF COMBINATION NUMBERS (D). SPIN SLOT

DOWNWARD, BRINGING SQUARE NOTCH TO BOTTOM OF

SLOT (E). PEN OR SCREWDRIVER RECOMMENDED.

3. SET NEW COMBINATION ON THE FRONT SIDE OF LOCK IN

LINE WITH ARROW.

4. MOVE SLOT BACK UPWARD TO ORIGINAL POSITION UNTIL

IT STOPS (F). NEW COMBINATION WILL BE SET.

1. SET LOCK TO UNLOCK MODE (SEE ABOVE), WITH

PLUNGER PULLED OUTWARD.

PLUNGER OUT: LATCH WILL BE LOOSE

PLUNGER IN: LATCH WILL BE LOCKED IN POSITION

National Products, Inc., 8410 Dallas Ave S., Seattle, WA 98108, (206) 763-8361 www.ram-mount.com

RMR-INS-TABD7

PARTS INDEX

A.) 1-QTY. BOTTOM IPAD DOCKING CUP

B.) 1-QTY. STEEL CLAMP PLATE

C.) 2-QTY. #4-40 X 1.25” FLAT HEAD MACHINE SCREWS

D.) 1-QTY. BOTTOM DOCK COVER

E.) 2-QTY. CABLE TIES (1 SPARE)

FOR SQUEEZE-TYPE DOCKING

CONNECTORS, USE SPARE (E)

CABLE TIE TO PERMANENTLY

PRESS SIDES TOGETHER.

1. (OPTIONAL) INSERT (E) CABLE TIE THROUGH

SLOT ON BACK OF (A)DOCK FOR WIRE RETENTION.

2. INSERT CONNECTOR THROUGH BOTTOM OF (A) DOCK. FRONT

SIDE OF CONNECTOR MUST FACE APPROPRIATE DIRECTION.

4. INSERT USB SIDE OF CABLE THROUGH (B) CLAMP

PLATE. INSERT CLAMP PLATE INTO (A) DOCK.

5. ATTACH (C) SCREWS TO HOLES ADJACENT TO PINS

USING PHILLIPS HEAD SCREWDRIVER UNTIL SNUG.

DO NOT OVER-TIGHTEN

6. ATTACH (D) BOTTOM COVER TO (A) DOCK,

SLOTTED SIDE FACING BACK.

7. (OPTIONAL) TIGHTEN (E) CABLE TIE AROUND

POWER CABLE TO PROVIDE CABLE RETENTION.

3. CAREFULLY PRESS CONNECTOR SO PINS

FULLY PROTRUDE FROM CENTER SLOT.

RAM UNI-CONN™ ASSEMBLY GUIDE FOR RAM TAB-LOCK™ & TAB-TITE™ SERIES