Ram-mount RAM Flush Rod Holder Wedge Adapter Manuel d'utilisateur télécharger pdf

National Products, Inc. 8410 Dallas Ave S. Seattle, WA 98108 206-763-8361 www.rammount.com

RAM FLUSH ROD HOLDER WEDGE ADAPTER ASSEMBLY INSTRUCTIONS

PARTS INDEX:

A. RAM BALL (SIZE MAY VARY) (QTY. 1)

B. TOP WEDGE WITH FLANGE (QTY. 1)

C. BOTTOM WEDGE (QTY. 1)

D. 1 9/16” RUBBER O-RING (QTY. 2)

E. STAINLESS STEEL SPRING (QTY. 1)

F. #10-24 X 6” MACHINE SCREW (QTY. 1)

G. #10-24 BRASS NUT (QTY. 1)

TOOLS REQUIRED:

SCREWDRIVER (ELECTRIC RECOMMENDED)

1. POSITION (D) O-RINGS OVER THE LARGER GROOVES

OF (B) TOP WEDGE AND (C) BOTTOM WEDGE.

3. DROP (G) NUT INTO (C) BOTTOM WEDGE. WHILE NUT IS

SECURE IN THE RECESSED HOLE, REMOVE (F) SCREW. SET

BOTTOM WEDGE ASIDE WITH NUT IN ITS PROPER POSITION.

5. WHILE HOLDING (G) NUT IN PLACE WITH FINGER, ATTACH

FROM STEP 4. THREAD (F) SCREW ONTO NUT BY HAND.

6. USING A SCREWDRIVER, TIGHTEN THE

WEDGE BASE ASSEMBLY UNTIL PRESSURE IS

APPLIED TO THE CENTER (E) SPRING. KEEP

WEDGES EXPANDED AS FAR AS POSSIBLE

WHEN TIGHTENING, ALLOWING SCREWDRIVER

TO PROPERLY TIGHTEN THE ASSEMBLY.

WHEN INSTALLING, USE SCREW DRIVER TO EXPAND OR CONTRACT THE RAM WEDGE ADAPTER

INSIDE VIEW

OF (C) WEDGE

(INSIDE)

4. INSERT (F) SCREW THROUGH (A) BALL, FOLLOWED BY (B) TOP WEDGE AND (E) SPRING.

2. INSERT (F) SCREW THROUGH NARROW SIDE OF (C) BOTTOM WEDGE.

THREAD (G) NUT ONTO END OF SCREW WITH ONLY A COUPLE TURNS.

RPR-INS-354-162